Flats with a built-in hob and a spur under the worktop
The spur has its own switch. Check it before assuming the hob has failed.
Gas appliance repairs · Colindale
A gas hob that suddenly stops sparking can be alarming, but the cause is often modest. The spark needs electricity, so a tripped fuse or a power cut will stop it. A spill can wet the electrodes or block the burner. The hob may still be fine, and a few checks will show. Residents of Colindale, where hobs are often built in and fused, can try them before asking the landlord for help.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Newer flats in Colindale often have a built-in gas hob with electronic ignition, powered by a socket or a fused spur beneath the worktop. If a spill reaches the electrodes, the spark may fail or fire constantly. If the power is off, nothing happens. A match is not the answer; the hob should be checked rather than lit by hand.
Work through the checks in order. Is the power on at the socket or the spur, and at the consumer unit? Switch every burner off and give the hob time to dry and cool. Lift the caps and wipe them and the bases dry. Check that the caps sit properly. Look for spills round the electrodes, and wipe them with a dry cloth. Try each burner in turn and note which, if any, will not light. If power and cleaning do not cure it, report the fault to the landlord or agent.
Heat Go can help put the fault in writing. Share what the hob does and what you tried, and a short report for the landlord can be drafted.
The spur has its own switch. Check it before assuming the hob has failed.
Water near the sink can reach the sparkers, so keep the worktop dry and mop up at once.
Dust and damp can build up. Clean and dry the burners before using them.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Flats with a built-in hob and a spur under the worktop | Permit zones | Kitchen | Spur switches |
| Flats with a hob close to the sink | Roadside | Open-plan kitchen | Splashes |
| Flats with a hob left idle for some time | Drives common | Galley kitchen | Idle hobs |
Tell the landlord or agent what the hob does and what you checked. Give them the hob’s make and model from the label.
A tenant finds her hob will not spark after a pan boiled over. She checks the spur, which is on, then lets the hob cool, lifts the caps and finds them wet. She dries them, seats them properly and the burners spark. Another burner stays dead, so she reports it to the agent with the make and model. An engineer finds the electrode damaged, replaces it and tests the hob. He leaves a note giving the electrode’s part number and the date, and the agent files it in the property record. The tenant learns to wipe splashes from the hob straight away and to keep a cloth by the cooker for the purpose. When a friend mentions the same trouble with a hob next door, she explains the steps and suggests reporting it in writing, with the make and model, which is exactly what the agent had asked of her.
A hob clean is easy in any season, but a check in September, before more home cooking in the cold months, finds trouble early.
A system that makes a spark by electricity to light the gas at the burner.
A switched, fused outlet that supplies a fixed appliance such as a hob.
A small metal tip that produces the spark beside a burner.
A power loss, a wet electrode or a dirty cap are the usual causes.
It is better to have the hob checked. Never leave gas flowing.
Turn off the hob, open windows, leave the flat and call 0800 111 999 first.
Usually the landlord arranges it. Report the fault in writing.
The make and model, what it does and what you tried.
Gas emergency
If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.
Talk to Heat Go
Tell Heat Go what your hob does, naming your Colindale road, and a short report for the landlord can be drafted.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.