Houses with radiators from the original installation
Age shows in the metal. Ask whether the other radiators are likely to follow.
Radiator installation & repairs · Muswell Hill
A stain on the skirting beneath a radiator, a damp patch on the carpet, a small bead of water forming on the lower edge: these are the marks of a pinhole leak. The steel has rusted through from the inside, usually at the bottom, where water and sludge sit. The hole is tiny, and the water comes slowly, but it will not stop by itself. Households in Muswell Hill, with older radiators, can recognise it and decide whether the radiator is worth saving.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Houses in Muswell Hill often have steel panel radiators fitted when the heating was installed, some thirty or forty years ago. The inside of such a radiator rusts over time, particularly if the system water was never treated. The bottom edge rusts first, because sludge collects there and keeps moisture against the metal. A pinhole can open at a weld or in the middle of a panel. The rest of the radiator is often in a similar state.
The opening steps are easy. Close the valves at both ends to stop the flow of water to the radiator, and put a tray beneath. Dry the area and mark where the leak appears, with a pencil. Look at the rest of the radiator for rust spots, bubbling paint or stains. Take a photograph of the leak. Tell the plumber, who can judge whether the radiator can be patched or should be replaced. A pinhole in a radiator of this age is rarely an isolated weakness, and replacement is usually the sounder choice, with the system checked for dirty water at the same time.
Heat Go can help you describe the leak. Send photographs of the radiator and the stain, and a short note for the plumber can be drafted.
Age shows in the metal. Ask whether the other radiators are likely to follow.
Untreated water speeds rust. Ask about a clean and an inhibitor.
The leak may have soaked it. Raise one corner of the carpet to look for damp.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Houses with radiators from the original installation | Roadside | Bedroom | Aged metal |
| Houses where the system was never treated | Drives common | Hall | Untreated water |
| Houses with carpet under the radiator | Permit zones | Landing | Soaked carpets |
Show the plumber the leak and the photographs. Tell them how old the radiator is and whether others have leaked.
A household in an older house finds a damp patch under the landing radiator. They close both valves, put a tray beneath and photograph a bead of water on the bottom edge. The plumber finds a pinhole near a weld and notes rust blisters along the base. He advises replacing the radiator, and tests the system water, which is dark. He fits a new radiator and adds a magnetic filter and inhibitor. The carpet dries, and the household files the invoice with the photographs. They plan to check the other radiators for blisters each autumn. The plumber recommends that they look at every radiator’s bottom edge with a torch each October, and mark any blister with a dab of paint so that it can be watched. They keep the old radiator’s rusted panel as a reminder in the garage, and add a line to the autumn list.
Leaks show up when the system is first used in autumn, so a look at every radiator in October, before the cold, catches weak ones early.
A tiny hole in metal, often made by rust eating through from the inside.
A joint in a radiator panel where two pieces of steel have been fused together.
A bubble or raised spot in a painted surface where rust is forming beneath.
Sometimes briefly, but replacement is usually wiser in an old radiator.
Sludge and moisture sit there and rust the metal.
Close the radiator’s valves and report the leak.
Possibly, if they are the same age and the water is dirty.
A filter and inhibitor in the system.
Talk to Heat Go
Pass Heat Go a picture of the leak and tell us your Muswell Hill road, and a brief note for the plumber can be written.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All central heating servicesEvery service in Muswell HillAll radiator installation & repairs areas