Houses with a disused chimney breast
A fire may be fitted, but the chimney needs checking and may need a liner. Say whether it has been swept or capped.
Gas appliance installation · Cockfosters
A new gas appliance is easy to choose and surprisingly easy to place badly. The shop sells the fire or hob, and the gas supply, ventilation and flue are left for later. By then, the units are ordered and the wall is chosen, and any mismatch is expensive to fix. A few questions asked before ordering save trouble. Households in Cockfosters can ask them at the planning stage.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Houses around the Piccadilly line terminus date largely from the years after the line opened in 1933, and many have had their kitchens and living rooms altered since. Think of a gas fire in a chimney breast that was once blocked, a hob moved to an island or a cooker shifted to a new wall: each calls for a gas pipe of the right size reaching a safe position. Planning decides whether that is simple or involved, and whether the plasterer needs to be told.
The planning questions are four. Where will the appliance stand, and how far is that from the existing gas supply? Does the position allow the ventilation the appliance needs, such as an air vent or an opening window? If it is a fire, is there a suitable flue or chimney, and what condition is it in? And what does the maker’s data sheet say about clearances to walls, worktops and units? The answers decide the route of the pipe and what must be built around it.
A new gas appliance is best discussed at the planning stage. The appliance, the position and the existing gas supply are what Heat Go needs to say what the installation is likely to involve. If the house ever smells of gas, walk out and call 0800 111 999.
A fire may be fitted, but the chimney needs checking and may need a liner. Say whether it has been swept or capped.
A hob on an island needs a gas pipe under the floor, and the floor’s construction decides how it can be laid.
In a flat, gas pipes may be shared and restrictions may apply, so raise it with the building’s agent first.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Houses with a disused chimney breast | Drives common | Living room | Old chimneys |
| Homes with a kitchen island plan | Roadside | Kitchen | Island hobs |
| Flats beside the last stop on the line | Permit zones | Stairwell | Shared supplies |
Show whoever visits the way to the room and the meter, and say where a vehicle can wait. If a floor must be lifted, mention the covering.
A couple plan to replace a worn-out gas fire with a modern one. They photograph the fireplace and the chimney breast, note that the chimney has not been swept for years and that the room has a window that opens. They send the data sheet of the fire they like. The reply covers what must be checked before fitting, including the flue and ventilation.
Gas fires are most wanted from October. Planning in September leaves time for the chimney to be checked and any lining or repairs to be done before the first cold evening.
The maker’s document listing gas type, clearances and ventilation. Keep a copy for the installer.
A tube inside a chimney that carries fumes safely. A fire may need one.
Distances to walls and units that the maker specifies. They must be respected.
No. The gas pipe, ventilation, flue and clearances all limit the position, and the data sheet sets out the limits.
Many fires need one, while some types bring their own flue. The data sheet for the model says which applies, and the chimney should be inspected either way.
Often, but the gas pipe must reach it safely and the floor must allow it, and the route should be settled before the worktop is made.
Many appliances do. Check the data sheet and the room, and ask the engineer whether an opening window would be enough.
A gas engineer. Gas work is not a do-it-yourself job, and a poor connection can be dangerous.
Gas emergency
If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.
Talk to Heat Go
An outline of the installation can follow once Heat Go has the appliance, the position and the name of your Cockfosters road. A gas smell goes to 0800 111 999 first.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All gas servicesEvery service in CockfostersAll gas appliance installation areas