Camden Town flats with a unit high on a wall
Warm air gathers there. A difference of a degree or two is common.
Air conditioning fault diagnosis · Camden Town
The display on an air conditioner shows the room temperature as the unit sees it. If that number seems wrong, the room may truly differ from what you feel, or the sensor may be reading a pocket of warm air near the unit, or it may be failing. A cheap thermometer can settle the question. Households in Camden Town can test the display against a second reading and write the results.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Flats in Camden Town are small, and a unit is often fixed high on a wall, where warm air rises and gathers. The sensor sits in the unit’s return air, and can read warmer than the room at head height. A display that stays several degrees off, or jumps about, suggests something more.
Five steps help. Stand a separate thermometer mid-room at head height, away from the sun, and leave it half an hour. Compare it with the unit’s display and note the difference, several times a day. Note whether the difference changes when the unit is running or off, which can show whether the sensor is influenced by the unit’s own air. Check that the sensor is not blocked by dust or by a curtain or shelf near the unit. And note any code. A steady difference of a degree or two is common, but one that grows or jumps may mean a faulty sensor. Give the engineer the readings.
Tell Heat Go where the unit and the thermometer sit, and a table comparing display and thermometer readings through the day will be set out.
Warm air gathers there. A difference of a degree or two is common.
It may block the sensor. Move it.
The sensor may be failing. Note the jumps.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Camden Town flats with a unit high on a wall | Roadside | Bedroom | High units |
| Camden Town: rooms with a curtain near the unit | Permit zones | Living room | Blocked sensors |
| Camden Town: units whose display jumps about | Drives common | Hall | Jumping displays |
Give the engineer the table of readings and tell him where the unit and thermometer sit. Show him the display when it seems wrong.
A tenant in a Camden Town flat notices that her unit’s display reads twenty-seven while the room feels cool. She puts a thermometer in the middle of the room and finds twenty-three. She compares them over four days and sees a steady gap of three to four degrees, which grows after the unit has run an hour. She finds a curtain close to the unit and moves it, but the gap stays. The engineer reads her table, tests the sensor and finds it drifting. He replaces it, and the display matches the thermometer. She files the table and the engineer’s note. The household also takes the thermometer reading on the first hot afternoon of the following year and finds the display and the thermometer agree to within a degree. They write both figures on the card in the folder, so that any future drift can be spotted at once. The tenant passes the card and the engineer’s note to the next occupant when she leaves.
Sensor faults show in the cooling season, when the unit runs long and the gap matters. A comparison in May, with a quiet room, gives a baseline. A sensor that has drifted may make the unit run too long or too little, so the check pays.
A device that measures the air temperature in a room and reports it to the unit’s controls.
The room air drawn into an indoor unit to be cooled or warmed.
A slow change in a sensor’s reading that makes it less accurate over time.
The sensor may be influenced by warm air or may be failing.
Check against a separate thermometer for a few days.
A degree or two often is.
Yes, if it blocks the sensor.
Safety first: ring 0800 111 999; while Camden Town air conditioning faults is secondary: leave, and Camden Town air conditioning faults can start again later.
Talk to Heat Go
Tell Heat Go where the unit and thermometer sit, and a comparison table for a few days will be drawn up.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All air conditioning servicesEvery service in Camden TownAll air conditioning fault diagnosis areas