Boiler installation · Camden Town

Boiler installation in Camden Town: a new kitchen extension with a rooflight and where the flue terminal may sit once the glazing has changed

A kitchen extension changes the outside of a house. New glass, new roof lines and new walls all affect where a flue may end. A terminal that sat safely on the old wall may now be too close to a window or beneath a roof edge. Households in Camden Town adding an extension and a boiler can settle the flue position at the design stage, not on the day.

Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.

Gas Safe Register WaterSafe Heat Go G3 certified Heat Go Heating and Plumbing Engineer

Houses and flats in Camden Town are often tight, with narrow gardens and neighbours close on both sides. An extension fills much of the space at the back. A boiler in the new kitchen needs a terminal on an outside wall, and the choices are few: the side return, the rear wall or the roof.

Five things need checking. The distance from the terminal to each opening, including glazed doors and rooflights, using the maker’s minimum distances. The distance to the boundary and to a neighbour’s windows. The effect of the roof edge or gutter above, which may trap fumes or drip on the terminal. Whether a plume kit can direct the vapour away from a door or a path. And where the flue will pass through the new structure, which must be sealed and sleeved. Ask the architect and the installer to agree the position together, and to mark it on the drawings. A change after the walls are built costs more than a change on paper.

Heat Go can draw up a flue position checklist for the architect and the installer if you tell it where the new doors and rooflights will be.

Agreeing the flue position with a new kitchen extension in a Camden Town home

Flue position questions for Camden Town extensions

Camden Town: terraces with a side return extension

The side wall is close to a neighbour. Ask about a plume kit.

Camden Town houses with large glazed doors on the new wall

Doors limit terminal positions. Ask for the distances to be measured.

Camden Town flats with a roof terrace above the extension

People stand near the terminal. Ask about safe distances.

SettingParking and van accessProperty accessTypical enquiries
Camden Town: terraces with a side return extensionRoadsideSide returnSide returns
Camden Town houses with large glazed doors on the new wallDrives commonKitchenGlazed walls
Camden Town flats with a roof terrace above the extensionPermit zonesTerraceRoof terraces

Give the installer the architect’s drawings and tell him where doors, rooflights and neighbours’ windows are. Say whether the walls are built yet.

A household in a Camden Town terrace plans a rear extension with a long rooflight and sliding doors. The installer reads the drawings and sees that the obvious place for the flue, the rear wall, now sits beside the sliding doors. He proposes the side wall with a plume kit and asks the architect to leave a sleeve in the brickwork. The distances are measured and marked on the drawing, and the sleeve is built in. The terminal is fitted without delay, and the household keeps the drawing with the paperwork for the building control file. The architect later writes to the household to confirm that the building control record shows the flue position, and the installer adds the sleeve’s details to his commissioning record. A neighbour planning a similar extension next door is shown the drawing and takes the same approach. The household keeps all three papers together with the extension’s plans.

Extension work runs through spring and summer, and the flue decision belongs near the start. A plan agreed in March can be built into the walls in May. Waiting until the boiler arrives risks cutting through finished brickwork and spoiling it.

Good to know in Camden Town

Rooflight

A window set in a roof that lets daylight into the room below.

Sleeve

A short tube built into a wall to carry a pipe or flue through it.

Terminal

The fitting on the outside of a building where a boiler’s exhaust gases leave.

Questions about boiler installation in Camden Town

01In Camden Town, does an extension change the flue position?

Yes, new glazing and walls change the allowed distances.

02In Camden Town, when should I decide?

At the design stage, before walls are built.

03In Camden Town, can a plume kit help?

It can direct vapour away from doors and paths.

04In Camden Town, who marks the position?

The installer and architect together, on the drawings.

05How does Camden Town boiler installation handle a gas smell?

Ring 0800 111 999 before anything; because Camden Town boiler installation waits until it is safe, and Camden Town boiler installation can proceed afterwards.

Gas emergency

An emergency should not wait for an online enquiry.

If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.

Talk to Heat Go

Ask about boiler installation in Camden Town.

Give Heat Go the extension’s drawings in outline, and a flue position checklist for both the architect and the installer will be set out.

The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.

Boiler installation enquiry

What can we help with?

All fields marked * are required

We reply to the contact details you give. A UK number such as 07700 900123 works fine.