Flats with a gas meter in a shared cupboard
Access may need a key. Ask the agent who holds it before an emergency arises.
Boiler breakdown diagnosis · Hendon
When the heating and the hot water fail together, the fault is usually something both depend on. That narrows the search to the power, the controls, the pressure, the gas supply or the boiler itself. A fixed order of checks, each taking a minute, finds the cause more often than guessing. Residents in Hendon can work through it with a torch and a pen, and tell any engineer exactly what was ruled out.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
A flat near the shops of Hendon Central typically has a boiler in a cupboard, a programmer on the wall and a gas meter in a communal or outside cupboard. Each of these is a possible point of failure. The checks start with those that are easiest to see and go on to those that need an engineer.
Work through six checks in order. Is there power? Look for lit lights on the programmer and the boiler. Are the controls calling for heat? Check the programmer and thermostat settings and turn them up. What is the pressure? Read the gauge against the maker’s range. Does the boiler show a code or light? Note it. Is gas reaching the home? If the hob will not light either, gas may be off at the meter, in which case the supplier is the first call. Last, press reset once, no more. Write down the result of each step.
Heat Go can go through the results with you. Tell us what you found at each step, and the next sensible move can be suggested.
Access may need a key. Ask the agent who holds it before an emergency arises.
An empty meter stops everything at once. Check the credit before assuming a boiler fault.
A tripped fuse silences it. Check the fuse board and the spur before anything else.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Flats with a gas meter in a shared cupboard | Permit zones | Meter cupboard | Meter access |
| Flats with a prepayment meter | Roadside | Hallway | Meter credit |
| Flats with the boiler on a separate fuse | Drives common | Kitchen | Fuse boards |
Tell the engineer which checks you have made and the result of each. A short list written in order is ideal.
A resident wakes to a cold flat and cold taps. She checks the programmer, which is lit, and turns it up. The boiler is dark. She finds the spur switch off, switches it on and the display lights. The gauge reads low, so she tops it up as the guide says and presses reset once. The boiler fires. She writes the steps on a card and keeps it in the cupboard. The next time the boiler stops, she follows the card in order and finds the tripped spur within a minute. When she tells the agent about it, he asks whether other residents would like the same list, and she offers to share it. The card gives the position of the meter cupboard and who holds the key, which proves as useful as the checks themselves. She also adds the phone number for the gas supplier’s emergency line at the bottom, so it is the first thing anyone sees.
A list of checks is most useful on the first cold morning. Writing it in September, with the positions of the switches and the meter, saves time later.
A switched, fused outlet that supplies power directly to a boiler.
A meter that stops the supply when the credit runs out.
A control that restarts a boiler after a safety lockout.
Something both depend on has stopped, such as power, gas or pressure.
Leave, open windows if safe and call 0800 111 999 before doing anything else.
No. One reset is enough; after that an engineer should look.
See whether the hob lights. If not, gas may be off at the meter.
Each check and its result, in order.
Gas emergency
If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.
Talk to Heat Go
Give Heat Go your results from the checks, with your Hendon street, and the next sensible move can be suggested.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All boiler servicesEvery service in HendonAll boiler breakdown diagnosis areas