Central heating installation · Hendon

Central heating installation in Hendon: installing a system in a flat where the flue and the pipes belong to the building

Installing central heating in a flat is not only a question of radiators and a boiler. The flue must leave the building somewhere, the pipes must cross floors and walls that may not be yours, and the work must not upset the people above, below and beside. Most of the delay in a flat installation comes from questions asked late. Residents in Hendon can ask them early, in writing, before a system is chosen.

Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.

Gas Safe Register WaterSafe Heat Go G3 certified Heat Go Heating and Plumbing Engineer

The flats around Hendon Central, where the station opened in 1923, sit above shops on parades whose backs, roofs and risers are shared. A flue outlet on a rear wall may need the freeholder’s consent, and pipes that cross a floor may pass a ceiling that belongs to a shop. A heating plan therefore starts with the building, not the boiler.

A sensible order has five steps. Check the lease for who owns the walls, the roof and the pipework, and what consent is needed. Ask the agent where a flue could leave the building. Decide where the boiler will sit, since a short flue and short pipes make the cleanest installation. Plan the pipe routes, with radiators on walls that can take them. And agree the work period with the neighbours, since drilling and noise carry through shared floors. Written notes of each answer prevent argument later.

Heat Go can help you list the questions to put to the agent before a system is chosen. Send a sketch of the flat and any lease wording on consent, and a short reply can follow.

Questions to settle before a central heating installation in a Hendon flat

Heating installation questions in different Hendon buildings

Flats above a parade of shops

The flue may have to leave through the rear. Ask the agent which walls may be used and what consent is required.

Flats in a block with a shared roof

A roof outlet is possible only with consent. Ask who owns the roof and whether anything is already fixed there.

Flats on the ground floor with a rear yard

The flue can often leave at the back. Ask about neighbours’ windows and the distance to boundaries.

SettingParking and van accessProperty accessTypical enquiries
Flats above a parade of shopsPermit zonesRear stairsFlue routes
Flats in a block with a shared roofRoadsideRoof hatchRoof consents
Flats on the ground floor with a rear yardDrives commonBack doorBoundary distances

Tell the installer who owns the walls and floors the pipes cross and whether the agent has been told. Keep each consent in writing.

A resident wants heating in a flat that has only electric heaters. She reads the lease and asks the agent where a flue could leave. The agent confirms a rear wall can be used with consent. The installer proposes a short flue, a boiler in the kitchen cupboard and pipes along the skirting. The neighbours are told the dates, the work is done in a few days and the system is tested and explained. The resident keeps the agent’s consent letter, the installer’s sketch of the flue route and the commissioning record together in one folder, ready for a buyer or a surveyor. When the building’s next inspection comes round, the paperwork is already in order and nobody needs to hunt through old emails.

A heating installation is best planned in summer, with consent obtained and equipment ordered, so that the system is ready before the cold arrives in October.

Good to know in Hendon

Flue

The pipe that carries the boiler’s exhaust gases safely out of the building.

Consent

Written permission from the freeholder or agent to carry out work affecting the structure or common parts.

Pipe run

The route a heating pipe follows from the boiler to a radiator.

Questions about central heating installation in Hendon

01Do I need permission to install heating in a flat?

Often yes, for the flue and any structural work. Check your lease.

02Where does the flue go?

Out through an outside wall or the roof, where the rules and the building allow.

03Will the neighbours be affected?

Possibly by noise, so warn them before the first drill is out.

04Can pipes run under floors?

Sometimes, if the floor structure and ownership allow.

05How long is a flat installation likely to take?

A flat can often be done in a few days, depending on the work.

Talk to Heat Go

Ask about central heating installation in Hendon.

Tell Heat Go about the flat, the lease wording and the street in Hendon, and questions for the agent can be set out.

The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.

Central heating installation enquiry

What can we help with?

All fields marked * are required

We reply to the contact details you give. A UK number such as 07700 900123 works fine.