Tufnell Park houses with a frost protection setting on the boiler
It starts near freezing. Check the setting and the temperature.
Boiler repairs · Tufnell Park
A boiler that fires in the small hours can wake a household and worry an owner. There are several harmless reasons, including a frost protection setting, a timer set for an early start or a thermostat doing its job. There are also faults that deserve a call. Telling them apart takes a few quiet observations. Households in Tufnell Park can make them in a night or two.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Large Victorian houses in Tufnell Park lose heat quickly on cold nights, and a thermostat may call for heat when a room drops below a set temperature. The programmer may have an early boost or a frost setting. Some boilers also run briefly to keep the water in the cylinder warm.
Five things to note. The time the boiler fires and for how long, over two or three nights. The outside temperature, since a frost setting starts at a low temperature. The programmer’s settings, including any boost, frost or night setback periods. The thermostat’s set point and the room temperature at the time. Whether it is a heating call, a hot water call or a call for both. A boiler that fires once in the night, near freezing, for a few minutes is probably in frost mode. A boiler that fires every hour on a mild night, with no call from the thermostat, may have a control fault. Take photographs of the settings.
Heat Go can set out a night log for two or three nights if you describe the programmer and the thermostat.
It starts near freezing. Check the setting and the temperature.
A pin may have shifted. Ask the engineer to check the times.
It may call for hot water. Note whether hot water is used.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Tufnell Park houses with a frost protection setting on the boiler | Roadside | Utility room | Frost mode |
| Tufnell Park homes with an old programmer | Drives common | Kitchen | Old programmers |
| Tufnell Park houses with a cylinder thermostat | Permit zones | Airing cupboard | Cylinder calls |
Show the engineer the log and the settings and say which nights were coldest. Tell him whether anyone has changed the programmer lately.
A household in Tufnell Park hears the boiler fire at three in the morning. They keep a log for three nights and note that it fires for five minutes each time, and that the outside temperature was close to freezing. The programmer shows no early start, but a frost setting is on. The engineer confirms that the boiler is in frost protection mode, a feature designed to guard the pipes. They leave it on for the winter. The log, with the engineer’s explanation, is filed so that the household need not worry again. At the following spring service, the engineer asks whether frost mode is still on, and the household says yes. He adds a note recommending that it stays on over winter and may be turned off in summer if the household prefers. The household writes both the winter and summer settings on a card by the programmer, and the next person who wonders about night firing can read the explanation there.
Night firing is most common in the coldest weeks, when frost settings come into play. A check of the settings in October clarifies what the boiler will do over winter. In spring, the same settings may not trigger at all.
A setting that starts a boiler when the temperature nears freezing, protecting the pipes.
A lower temperature setting for the hours of the night.
A setting that runs the heating outside its usual times for a brief period.
Frost mode, a timer or a thermostat may be the cause.
No, it protects the pipes.
Keep a log and photograph the settings.
If it fires often on mild nights with no call for heat.
Get out; 0800 111 999 first, until then, Tufnell Park boiler repairs stops for now, and Tufnell Park boiler repairs carries on later.
Gas emergency
If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.
Talk to Heat Go
Describe the programmer and thermostat to Heat Go, and a night log sheet will be drawn up.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All boiler servicesEvery service in Tufnell ParkAll boiler repairs areas