Houses with a gauge on the boiler front
It is easy to see. Ask the engineer what range is normal for the model.
Boiler repairs · Whetstone
A boiler that keeps losing pressure is a common call. The gauge on the front shows a needle or a number, and its behaviour over a few days is a clue. A household that writes down what it sees gives the engineer a head start. Households in Whetstone can keep a very short log, using nothing but a pen and a phone camera, and hand it over at the visit.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Houses in Whetstone often have sealed heating systems with a small gauge on the boiler or the pipework beside it. Normal readings are marked on the dial, and the maker’s booklet gives the range for each model. A needle that sits steady in the range is normal. A needle that creeps down over days, or climbs high when the heating runs, is worth recording. The household should not release water or force a valve to change it.
The log has four columns. The date and time. The reading with the heating off and the pipes cold. The reading after the system has been warm for a while. And anything seen at the same time, such as a damp patch, a drip from a pipe, a noise or an error on the display. Take a photograph of the gauge each time, with the date visible if the phone allows it. After a week the pattern is usually clear to an engineer: steady, falling slowly, falling fast or rising when hot. Each points to a different place to look. Do not top up the system unless the maker’s booklet shows how and you are confident. If unsure, wait for the visit.
Heat Go can assist with the log. Say what the gauge shows, and a one-page table to fill in can be written for you.
It is easy to see. Ask the engineer what range is normal for the model.
The gauge may be hard to see. Photograph it with the door open and a torch.
More water means a different pressure pattern. Tell the engineer what has changed.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Houses with a gauge on the boiler front | Roadside | Kitchen | Front gauges |
| Houses with the boiler in a cupboard | Drives common | Landing cupboard | Hidden gauges |
| Houses where radiators have been added | Permit zones | Extension | New radiators |
Give the engineer the log, the photographs and the date the pressure first dropped. Say whether anyone has bled a radiator or topped up the system recently, because both change the pattern. Mention any work on pipes under floors or behind walls since the last service.
A household in a semi-detached house notices the needle dropping towards the bottom of the dial each week. They photograph it for seven days, write down the readings and note a damp patch on a kitchen ceiling after two days. The engineer reads the log, sees the pattern and traces the loss to a joint under the bathroom floor rather than the boiler itself. The log saves an hour of searching, and the household keeps a copy with the other boiler papers.
Pressure problems often show up as the heating returns in autumn, so starting a log then gives a week of readings before the first cold snap, and a clear record for the visit that follows.
A dial or display on a sealed system showing the water pressure in the heating circuit.
A heating circuit closed to the atmosphere that holds water under pressure.
A short flexible pipe used to add water to a sealed heating system.
It varies with the model. The range is marked on the dial and in the booklet.
A leak, a valve or an expansion vessel could be at fault. An engineer must check.
Only where the maker’s booklet shows how and you are sure. Otherwise wait for the visit.
Yes. A week of readings points an engineer to where to look first.
Walk outside, make the 0800 111 999 call as the very first step and avoid switches and flames. The enquiry form is the wrong route for a gas emergency.
Gas emergency
If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.
Talk to Heat Go
Tell Heat Go what the gauge on your Whetstone boiler is doing, and a one-page log to fill in can be written for you.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All boiler servicesEvery service in WhetstoneAll boiler repairs areas