Plumbing repairs · Golders Green

Plumbing repairs in Golders Green: old isolating valves that will not close when you need them

The moment a pipe bursts is the worst time to find that the valve will not turn. Old isolating valves, the small taps under basins and beside toilets, seize with age and disuse, and the stopcock can be just as stubborn. A few minutes spent testing them, before anything goes wrong, can turn a flood into a mop-up. Households in Golders Green, many in homes that have stood for a century, can run the test this weekend, in about half an hour.

Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.

Gas Safe Register WaterSafe Heat Go G3 certified Heat Go Heating and Plumbing Engineer

Houses crowded the streets round the station after it opened on 22 June 1907, and went on being added for decades. Many have had their plumbing renewed in stages, so valves of several ages sit in the same house, and the oldest are the ones that matter most in an emergency. The oldest are often brass, grey with scale, and have not been turned for years. Where a valve has never been moved, it is more likely to be stuck than where it has been turned regularly, and a valve that was last turned by a previous owner is a prime suspect.

The routine is short. Find every isolating valve in the house: under the kitchen sink, behind the toilet, under each basin, beside the washing machine, at the cylinder. Turn each a quarter turn to close and then open it again, gently, noting any that are stiff, weep at the spindle or will not move. Do not force one, because a snapped spindle turns a minor job into a flood. Find the stopcock, usually beneath the kitchen sink or in the entrance hall, and do the same. Write down the position of each valve, and which fittings it serves.

Heat Go can say which valves are worth replacing and what to tell an engineer. Send a list of those that are stiff, with photographs, and a short reply can follow.

Testing isolating valves in a Golders Green house

Valve problems in different Golders Green homes

Houses with original brass valves

Brass seizes with scale. Test them early, and expect to replace the stiffest.

Houses with a cylinder cupboard

The valves round the cylinder are the least used and the most stuck. Check them.

Flats in lift-served blocks

Lifts make visits easy, but the stopcock may sit in a shared cupboard, so ask the agent.

SettingParking and van accessProperty accessTypical enquiries
Houses with original brass valvesRoadsideKitchenOld brass
Houses with a cylinder cupboardDrives commonLandingCylinder valves
Flats in lift-served blocksPermit zonesCommon stairsShared stopcocks

Hand the plumber the sketch of valves and mark the stuck ones. Explain how to reach the stopcock and whether anything has been built round it.

A couple spend half an hour one Saturday turning each valve in the house. Two under-sink valves and the stopcock are stiff, and the valve behind the upstairs toilet will not move at all. They photograph each, mark them on a sketch and send the list to Heat Go. The reply suggests replacing the toilet valve and the stopcock at the same visit, and oiling the others lightly.

Valves are most needed when pipes freeze and burst, in the first deep cold of winter. Testing them in October, with the heating just on, leaves time to replace the stuck ones.

Good to know in Golders Green

Stopcock

The main tap that shuts off the water to the whole house. Everyone at home should know where it is.

Quarter-turn valve

A valve that closes with a quarter turn of its handle. It is easy to test.

Seized valve

A valve that will not turn because of scale or age. It must not be forced.

Questions about plumbing repairs in Golders Green

01Why do isolating valves seize?

Scale builds up and the washer hardens. Valves that are never moved are the likeliest to stick.

02Can I free a stuck valve?

Gentle movement may help, but forcing can break it. A plumber can replace it.

03Where would the stopcock be?

Most often under the kitchen sink or in the hall near the front door, and today is a good day to find it.

04How often should I test my valves?

Once a year, in autumn, takes ten minutes.

05What if a valve leaks when I turn it?

Stop, close the stopcock if needed and report it. The spindle seal has failed.

Talk to Heat Go

Ask about plumbing repairs in Golders Green.

Send Heat Go your sketch and photographs and your Golders Green road, and a view on which valves to replace can follow.

The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.

Plumbing repairs enquiry

What can we help with?

All fields marked * are required

We reply to the contact details you give. A UK number such as 07700 900123 works fine.