Houses with a unit in a damp, shaded corner
Damp air frosts the coil faster. Ask whether a different position would help.
Heat pump repairs · Golders Green
In cold, damp weather the outdoor coil of a heat pump collects frost. The unit melts it with a defrost cycle, during which it briefly stops heating the house and may give off steam. That is normal. If it seems to happen every few minutes, or the house cools noticeably between cycles, something may be wrong. Households in Golders Green can note how often it happens and what the weather is doing.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
In bigger Golders Green houses the heat pump often has a large outdoor unit, and the cycle is more visible on a cold, misty morning. Frequent defrosting can point to a dirty coil, restricted airflow, a sensor reading wrongly or a refrigerant problem. The weather itself matters: just above freezing with high humidity is the worst case, and a dry, hard frost is much easier.
A householder can make five notes. The date, time and outdoor temperature when defrosts occur. How long each defrost lasts and how long the unit runs between them. What the controller shows during a cycle. Whether the house cools noticeably in between. And what the area round the unit looks like: leaves, snow, ice or anything near the coil. A set of notes over a few days gives the engineer a pattern to work with.
Heat Go can go through your notes with you, and a view on whether the cycles look normal can be offered.
Damp air frosts the coil faster. Ask whether a different position would help.
Leaves and drips add to the load. Clear the area and trim overhanging branches.
Cold air may recirculate. Check the clearance against the maker’s figure.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Houses with a unit in a damp, shaded corner | Roadside | Back corner | Damp air |
| Houses with a unit under a tree | Drives common | Garden | Leaf and drip |
| Houses with a unit close to a wall | Permit zones | Side wall | Recirculation |
Give the engineer your defrost log and photographs of the unit and its surroundings. Tell them how the house felt between cycles.
A household notices the pump defrosting every twenty minutes on misty mornings. They log the times and temperatures and photograph the coil, which has leaves on its face. They clear the leaves, switch off first, and the cycles space out to every ninety minutes. The engineer, shown the log, checks the sensor and finds it sound. He advises trimming a branch above the unit. The household keeps the log. The engineer adds that a long, damp spell in November is the best test of whether a unit is well placed, and recommends they watch the pattern again then. They agree to keep the log running through winter, with a line for each cold spell. By February, the log shows that the cycles have settled to a steady rhythm, and the house stays warm between them. The entries are filed with the unit’s papers for the next service. The engineer adds a short entry to his own sheet, referring to the log. He thanks the household for the detail, which let him confirm in minutes that the unit was behaving normally, and advises that they continue the log only in the coldest spells, when defrosting is most likely to puzzle them. The household agrees to keep a shorter version and to share it at the next service.
A defrost log is easiest to start on the first cold, damp week of autumn, when patterns appear.
A brief spell when the outside unit thaws frost off its coil, pausing the heating.
The finned face of the outside coil, where air enters the unit.
The amount of water vapour in the air, which affects how fast frost forms.
Yes, in cold, damp weather, at reasonable intervals.
Every few minutes, or with a noticeable chill indoors, is worth reporting.
Remove leaves with care, with the unit off, and let an engineer do any real cleaning.
Yes. Damp, just above freezing, is the worst.
Times, temperatures, durations and the unit’s surroundings.
Talk to Heat Go
Pass Heat Go your defrost log and your Golders Green address, and a view on whether the cycles look normal can follow.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All heat pumps servicesEvery service in Golders GreenAll heat pump repairs areas