Flats
Individual controls are easy to adjust, but keys and access must be arranged for repairs.
Thermostats & heating controls · Edmonton
In a rented home, the heating controls are often the one part of the system the tenant touches every day, and the part they know least about. A dial that is turned up and down in hope, a timer nobody dares to change and a boiler that seems to have a mind of its own are all common. This page helps Edmonton tenants, owners and landlords make sense of the controls.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Edmonton Green, with its bus station, is surrounded by flats, maisonettes and terraces, many of them let. The controls in them range from a basic mechanical timer to a smart thermostat installed by a landlord who wanted remote visibility. Whatever is fitted, the tenant lives with it, and getting the settings right makes the home both comfortable and cheaper to run than a poorly set system.
Because tenants cannot always change equipment, the most useful step is to understand what can be adjusted safely, and what should be left alone until the landlord has been asked. The target temperature on the thermostat, the on and off times on the programmer and the settings on radiator valves are all within reach. Replacing or rewiring the controls is the landlord’s decision, and a clear report of what is wrong makes it easier for the landlord to act.
Simple adjustments, what to record before reporting a fault and what a landlord might weigh up if the controls are outdated can all be covered. Tell Heat Go if you rent, own or manage the home and if the boiler serves only your flat, and the reply can be pitched accordingly. A photograph of the thermostat and timer helps greatly.
Individual controls are easy to adjust, but keys and access must be arranged for repairs.
One thermostat may serve two floors, so the upstairs can overheat.
Controls are often with the managing agent, so tenants can only adjust radiator valves.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Flats | Check signs | Keys needed | Simple settings. |
| Maisonettes | Limited | Shared door | Two floors. |
| Communal systems | Roadside | Plant room | Valve settings. |
Buses stop beside Edmonton Green, which makes the bus station an easy place to meet. For the visit, name the floor and entrance, give a contact who can open the door and say which room holds the thermostat.
A tenant finds that the heating comes on at 4 a.m. and goes off at 8, though she is asleep at the first time and out at the second. She photographs the timer, notes the times and asks her landlord to help reset it. The details let the landlord see at once that the timer has the wrong schedule, and a visit can be short.
Colder weather draws attention to controls. A quick review in October, with the timer checked and a note of settings, makes the first cold week smoother.
The nearby Silver Street stop is a useful second reference, alongside the Green itself, when describing a property’s position.
Tenants generally need the landlord’s agreement before replacing controls. Ask first and describe what you want.
A note of the settings you use, kept on your phone, helps if the controls reset after a power cut.
The landlord must say yes before any change. Set out what is wrong and what you would like, and make the request in writing so there is a record.
The timer may have the wrong time or schedule. Photograph it and note the times it shows.
It depends on the home and the system, so there is no simple rule. Note your pattern of use, when people are in, and how quickly the flat cools when the heating is off, and the reply can be specific.
It may need new batteries or may have failed. Try fresh batteries first, note whether the screen returns, and report it with a photograph if it does not.
Only with consent, and it must suit the boiler. Ask the landlord first.
Talk to Heat Go
Who owns the home, which controls it has and an Edmonton postcode let the reply fit your situation.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All central heating servicesEvery service in EdmontonAll thermostats & heating controls areas