Houses with a loft-fed cylinder
The cylinder holds a lot of water and takes time to heat. Ask how early the heating must start for morning use.
Thermostats & heating controls · Mill Hill
A programmer is the clock that tells the boiler when to heat the house and the hot water. The settings are often left as they were first made, even when the household’s routine has changed. A cylinder heated at the wrong time wastes effort, and a house heated when nobody is at home does the same. Households in Mill Hill can revisit the settings once a season and keep them in line with how they live.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Many Mill Hill houses have a programmer with separate times for heating and hot water, and a cylinder in an airing cupboard fed from a loft tank. The cylinder takes time to heat and holds the heat for hours. The heating times are set to match when the household is up and out, and may need to change with the seasons.
To set the times, start with the household’s routine. Note when people get up, leave, return and go to bed. Set the heating to come on shortly before waking and before return, and to go off before bed and departure. Set the hot water to heat once or twice a day, early enough for the morning shower and long enough to refill after use. Check the cylinder thermostat is at a sensible setting. Test the schedule for a week and adjust.
Heat Go can help you plan a schedule. Tell us about the household’s routine and the controls you have, and a first draft of the settings can be suggested.
The cylinder holds a lot of water and takes time to heat. Ask how early the heating must start for morning use.
Heating may be wanted through the day. Ask about separate settings for the rooms you use.
Pins or tabs set the times. Ask whether a digital one would suit the household better.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Houses with a loft-fed cylinder | Drives common | Airing cupboard | Cylinder timing |
| Houses with a household that works from home | Roadside | Study | Daytime heating |
| Houses with a basic dial programmer | Permit zones | Kitchen | Basic timers |
Tell the engineer how the household uses the house and which times matter most. A written routine is helpful.
A household finds the hot water is cool in the morning and the house is warm when everyone is out. The engineer looks at the programmer and finds the times were set years ago. They write down the household’s routine, move the hot water earlier and the heating later, and shorten the evening period. The next week, the shower is hot and the house is warm only when needed. The engineer also fixes the cylinder thermostat at a steady setting and shows the household how the boost button works, so that an unexpected visitor or a cold evening can be dealt with by hand. The household writes the times on a card inside the airing cupboard door, so that they are easy to find at the next change of season, when the clocks go back and the routine shifts. The household also notes that the programmer’s battery backup keeps the time through a short power cut, which the engineer checks before leaving.
A programmer needs adjusting twice a year, in spring and autumn. A September review sets it for the heating season.
A timer that sets when the heating and hot water come on and go off.
A sensor on the cylinder wall that signals the boiler once the stored water is hot.
A button that turns the heating or hot water on for a short extra period.
Review it each season, and whenever your routine changes.
It varies. Allow time before the morning shower.
The times may be wrong or the thermostat set low.
Not usually. Set the times to match your routine.
It adds a short extra period of heating or hot water.
Talk to Heat Go
Tell Heat Go how the household uses the house, with your Mill Hill street, and a first draft of settings can be suggested.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All central heating servicesEvery service in Mill HillAll thermostats & heating controls areas