Houses with a glazed kitchen-diner
Large panes shed warmth fast. Ask how the emitters will offset the chill near the doors.
Central heating installation · Whetstone
A new extension changes how a house is heated. Its large glass doors, its different floor and its use make it behave unlike the rooms around it. Hanging a few more radiators on the old system and hoping rarely works. A separate zone, with its own thermostat and valve, lets the extension be warmed when it is used and left alone when it is not. Households in Whetstone can ask about it at the design stage, before the walls are plastered.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Houses in Whetstone are often extended at the back, with a kitchen-diner opening to the garden. The boiler may have been sized for the original house, and the pipes may run from the kitchen along the old ceiling. An extension adds heat loss, and perhaps underfloor heating. Whether the boiler can serve the new zone depends on its output and the layout of the pipes.
The design has six elements. The heat loss of the extension, calculated from its walls, glass and floor. The boiler’s output, compared with the old house’s needs and the new zone’s needs combined. The type of emitter: radiators, underfloor heating or both. The zone valve and the second thermostat, wired to the boiler. The pipe route from the existing system to the extension, planned before the floor goes in. And the controls, so that the zones can be timed separately. A written specification shows what is being done.
Heat Go can work out a zone with you. Send the plans of the extension and the boiler’s details, and several points to raise with the installer can be set out.
Large panes shed warmth fast. Ask how the emitters will offset the chill near the doors.
Its output may be tight. Ask whether it can serve a further zone.
The floor build-up and the flow temperature matter. Ask how it will be mixed down.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Houses with a glazed kitchen-diner | Roadside | Kitchen-diner | Large glass areas |
| Houses where the boiler is a few years old | Drives common | Utility room | Spare capacity |
| Houses with underfloor heating planned in the extension | Permit zones | Rear extension | Underfloor loops |
Give the installer the extension’s plans, the boiler’s make and age and the way the room will be used. Say when the floor is due to be laid.
A household plans a rear extension and asks the installer for a separate heating zone. He calculates the new room’s heat loss and finds the boiler has spare capacity. He fits a zone valve, a second thermostat and underfloor pipes before the screed. The extension is controlled on its own timer. When the household is out, the extension is left at a low setting. The household keeps the specification and the wiring diagram. The installer also explains that a zone with underfloor heating should not be switched on and off at short intervals, since the screed warms and cools slowly, and recommends a gentle timer. The household sets the extension to a low background level during the day and a comfortable one in the evening, writes the settings on the wiring diagram and files it with the boiler’s papers. By midwinter, the room has proved its worth.
Heating pipes go in before floors, so planning belongs at the start of a build. A summer start leaves the system ready before the cold arrives.
A motor-driven valve that admits hot water to one part of the house, or closes it.
The speed at which a room sheds its heat to the weather.
A level topping of cement and sand that may bury underfloor heating pipes.
Often, since it behaves differently from the rest of the house.
Sometimes, if its output allows. The installer will check.
Before the floor is laid.
A zone usually needs its own.
Yes, with the right controls.
Talk to Heat Go
Pass Heat Go the plans of your extension along with the Whetstone road you live on, and a list of matters to raise with the installer can be set out.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All central heating servicesEvery service in WhetstoneAll central heating installation areas