Flats with storage heaters
These are bulky and slow to control. Ask what could replace them and what the wiring allows.
Central heating installation · Wood Green
Many flats have no gas. They may have storage heaters, a few wall panels or nothing at all, and their residents ask what a proper system would involve. Without gas, the choices are electric: an electric boiler feeding radiators, a small heat pump or a set of electric radiators with controls. Each has different running costs, space needs and permissions. Residents in Wood Green can put the options to an installer and compare.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Many flats in Wood Green’s blocks and conversions have no gas supply, or have a meter that serves only a cooker. Running gas to a flat needs the freeholder’s consent and may not be possible. An electric system uses the existing supply, though it may need a larger fuse or a new circuit. The flat’s insulation and size decide what is suitable.
The comparison covers six points. The size and insulation of the flat, which set its heat need. The electrical supply: its capacity and the consumer unit. The space for equipment: a boiler and cylinder, a heat pump unit or just radiators. The consent needed from the freeholder or agent. The running costs, which the installer should estimate on stated assumptions, not promises. And the controls and how they are used. Ask for each option in writing, with its advantages and its limits.
Heat Go can lay out the options. Tell us about the flat, and a set of questions can be prepared for the installer.
These are bulky and slow to control. Ask what could replace them and what the wiring allows.
An outdoor unit has nowhere to go. Ask about the options that need none.
Heat rises and the roof is exposed. Ask for the insulation to be checked first.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Flats with storage heaters | Permit zones | Living room | Storage heaters |
| Flats in a block with no outside space | Roadside | Bedroom | No outdoor space |
| Flats on the top floor | Drives common | Top landing | Roof heat loss |
Give the installer the flat’s plan, the electricity supply details and any lease clauses about alterations. Tell them how the flat is used.
A resident in a flat with storage heaters asks about a proper system. The installer surveys it and compares an electric boiler, a small heat pump and electric radiators with timers. The flat has no outdoor space, so a heat pump is out. The agent agrees to an electric boiler in a cupboard. The consumer unit is updated and the radiators are fitted. The resident keeps the comparison and the agent’s letter. The installer adds that electric heating works best with good controls, and sets up a timer for each room, with a lower setting overnight. He leaves a short guide to the settings and a note of the consumer unit changes, and the resident files them with the lease papers. She finds that the flat stays steadily warm, and that she no longer needs to remember to switch the storage heaters on the night before a cold snap. The agent, told of the change, asks whether the same approach might suit the flat below, and she shares the installer’s name and the plan. The installer’s sketch, shown to the agent, helps to explain what is proposed and avoids a round of confusing questions.
Consents take time, so a start in late summer gives time for approval and fitting before the cold.
A boiler that heats water using electricity, feeding radiators in the usual way.
An electric heater that stores heat overnight and releases it during the day.
The fuse board that distributes electricity to the flat’s circuits.
Yes, using electric boilers, heat pumps or electric radiators.
Often, for new equipment, pipes or outdoor units.
The installer will check and say if it needs updating.
By estimates on stated assumptions, not promises.
In a cupboard, or on a wall, depending on the option.
Talk to Heat Go
Describe your flat and its present heating to Heat Go, with the Wood Green address, and a set of questions can be put to the installer.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All central heating servicesEvery service in Wood GreenAll central heating installation areas