Central heating installation · Edgware

Central heating installation in Edgware: radiators, underfloor heating or both, and what each asks of the building

When a new heating system is planned, the choice between radiators and underfloor heating comes up early. Radiators are familiar, quick to respond and easy to fit. Underfloor heating spreads the warmth across the floor and frees the walls, but it needs a suitable floor and a boiler or system that works at lower temperatures. Households in Edgware can weigh each against their house before deciding.

Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.

Gas Safe Register WaterSafe Heat Go G3 certified Heat Go Heating and Plumbing Engineer

Houses and flats around Edgware station, which opened in 1924, include homes with timber floors, concrete floors and recent extensions. Underfloor heating suits a new concrete floor in an extension, where the pipes can be laid before the screed is poured. Retrofitting it into an upstairs timber floor is harder, and often radiators are the practical choice there.

Five points guide the choice. The floor: concrete can take pipes in a screed, timber needs special panels or plates. The height: underfloor systems add a few centimetres to the floor, which affects door heights and stairs. The speed: radiators heat a room fast, underfloor heating more slowly but evenly. The boiler: underfloor heating works best with a low flow temperature. And the covering: some floor finishes insulate and slow the heat. A mix of the two, with underfloor heating in an extension and radiators elsewhere, is common.

Heat Go can help you compare options for a house. Send a plan with floor types marked, and a few questions for the installer can come back.

Comparing radiators and underfloor heating for an Edgware home

Heating choices in different Edgware homes

Houses with a new concrete extension

Pipes can be laid in the screed. Ask about the insulation under them and the thickness of the build-up.

Houses with upstairs timber floors

Underfloor heating is possible with special panels, but radiators are often simpler. Ask about both.

Flats with a limited ceiling height

A raised floor takes headroom. Ask for the exact build-up before choosing.

SettingParking and van accessProperty accessTypical enquiries
Houses with a new concrete extensionDrives commonRear doorScreed laying
Houses with upstairs timber floorsRoadsideLandingTimber floors
Flats with a limited ceiling heightPermit zonesHallwayFloor height

Tell the installer which rooms have concrete floors, which timber, and whether the floors will be redone.

A couple extend the back of the house and plan a new kitchen. The installer suggests underfloor heating in the extension, where the screed is being laid, and radiators in the rest of the house. The pipes are laid and pressure-tested before the screed goes in. The boiler is set to a lower flow temperature for the underfloor loop, and the couple find the kitchen warm and the walls clear for units. The installer leaves the manifold in a cupboard with each loop labelled, and the couple file the pressure-test record with the building papers. The radiators elsewhere are fitted with thermostatic valves, so that the rooms can be balanced after a week of use, and the whole system is revisited at the first service. On that visit the engineer checks the pressure, the flow in each loop and the settings of the controls, and writes the figures on the commissioning record. The couple later find that the kitchen floor feels pleasantly warm underfoot on an ordinary morning, while the radiators in the bedrooms respond quickly when the thermostat calls for heat, and the household simply keeps the same schedule year after year without needing to adjust anything.

Underfloor pipes must be laid before a screed or floor is finished, so the decision comes early in a build. Settling it in summer leaves time for design and ordering.

Good to know in Edgware

Screed

A thin layer of cement or similar material laid over a floor, sometimes covering underfloor pipes.

Flow temperature

The temperature of the water leaving the boiler to heat the system.

Manifold

A fitting that splits the flow into separate underfloor circuits.

Questions about central heating installation in Edgware

01Is underfloor heating better than radiators?

It depends on the floor, the budget for the work and how you use the room.

02Can it be fitted on timber floors?

Yes, with special panels, though radiators are often simpler.

03Does it heat up slowly?

More slowly than radiators, but it warms evenly.

04Does it work with any boiler?

It works best with low flow temperatures. Ask the installer.

05Can I mix both?

Yes, many homes use underfloor heating in one area and radiators elsewhere.

Talk to Heat Go

Ask about central heating installation in Edgware.

Send Heat Go your plan and Edgware road, and a list of questions about the two options can be drawn up.

The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.

Central heating installation enquiry

What can we help with?

All fields marked * are required

We reply to the contact details you give. A UK number such as 07700 900123 works fine.