Central heating installation · Barnet

Heating installation in Barnet: splitting a tall house into heating zones

A tall house is difficult to heat evenly. Warm air rises, so the top floor can be hot while the ground floor stays cool, or the reverse in spring when the living areas need little but the bedrooms are chilly at night. A single thermostat cannot satisfy every room. Splitting the system into zones, each with its own controls, lets each floor be heated when needed. Households in Barnet planning an installation can plan zones from the beginning.

Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.

Gas Safe Register WaterSafe Heat Go G3 certified Heat Go Heating and Plumbing Engineer

The Northern line began serving High Barnet on 14 April 1940, and the roads that climb the hill around Chipping Barnet include houses of three storeys, including some with converted lofts and basements. Such homes have long vertical runs for pipes and large differences in temperature between floors. A zoned system takes account of both, and the cost of planning it at the outset is small beside the cost of adding it later.

A zone is a part of the system that can be switched on and off separately, controlled by a motorised valve and a thermostat or timer. Common divisions are ground floor, first floor and a loft conversion, or day areas and night areas. Each zone needs a valve, a thermostat and wiring back to the programmer, and the wiring needs a route through walls or ceilings that should be agreed before the plastering is finished. Radiators within a zone are still balanced against each other, so the plan must consider flow and return together, and each branch must carry enough water to keep the furthest radiator warm.

Zoning is easiest to settle on paper. Describe the floors, which rooms are used when and where the boiler will go, and Heat Go can suggest how the house might be divided and what controls each zone would need.

Thinking about zones for a tall Barnet house

Zoning in different Barnet homes

Three-storey houses

Separate zones for each floor let heat follow use. The pipe riser should be planned so each zone can branch from it.

Houses with loft conversions

A converted loft loses heat quickly and may need its own zone and controls. Say how it is insulated, whether the roof was lined with boards or insulation, and how many people sleep up there.

Large flats over two levels

A maisonette can be divided into upstairs and downstairs zones, subject to the building rules.

SettingParking and van accessProperty accessTypical enquiries
Three-storey housesRoadsideHallwayFloor zones
Houses with loft conversionsDrives commonLandingLoft zone
Large flats over two levelsPermit zonesCommon stairsTwo levels

Explain the way to the loft, the airing cupboard and any basement, and where pipes will need to rise. Notes on stairs and turns help when radiators are carried to the upper floors.

A family in a three-storey house find that the bedrooms are warm by evening while the kitchen is cold in the morning. They sketch the three floors, mark their use and note that the loft is a bedroom. A zoned plan is discussed: ground floor, first floor and loft, each with its own thermostat. Heat Go can say that three valves, a programmer and a vertical riser are needed.

Early autumn brings days where one floor is warm and another cold. Planning zones in September lets the system be installed and commissioned before the heating season proper begins.

Good to know in Barnet

Zone valve

A motorised valve opens or closes the flow to one part of the system, controlled by a thermostat or timer.

Riser

The vertical pipes that carry water between floors. Their position is planned early.

Zone thermostat

A device in one zone that tells its valve when to open. Position matters greatly.

Questions about central heating installation in Barnet

01How many zones does a house need?

It depends on the layout. Two or three suit most tall houses.

02Can zoning be added later?

Sometimes, but it is easier and tidier if planned during installation.

03Does each zone need its own thermostat?

Yes, usually, so each can be controlled independently. In some homes one programmable room thermostat serves two zones with different time settings, but separate devices give the clearest control.

04Will zoning reduce the need for radiators?

No. Radiators still need to be sized for each room.

05What if the boiler is in the basement?

It can serve the whole house, with risers to the upper floors.

Talk to Heat Go

Ask about central heating installation in Barnet.

Heat Go can suggest a zoning plan once it has the floors, the room uses and your Barnet road, and the plan can be refined after a survey of the pipe routes.

The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.

Central heating installation enquiry

What can we help with?

All fields marked * are required

We reply to the contact details you give. A UK number such as 07700 900123 works fine.