Houses with a side utility room
The outside wall is close, so the flue is short. Ask how the new pipes will cross to the kitchen and bathrooms.
Boiler installation · Mill Hill
A new boiler does not have to go where the old one stood. Many households take the chance to move it to a utility room, a garage or a loft, freeing a kitchen cupboard. The move changes the flue route, the pipe runs and the drain for the condensate, and each must be planned. Households in Mill Hill can decide whether the benefit is worth the extra work before asking for a quote.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Houses around Mill Hill often have a utility room or garage at the side or back, with an outside wall suited to a flue. Moving the boiler there shortens the flue but lengthens the pipes to the radiators and the hot water outlets. The pipes must be run through walls or under floors, with insulation and clips, and the condensate pipe needs a route to a drain.
These are the main considerations. Flue: the boiler must sit where the flue can reach an outside wall or the roof within the maker’s limits, and the terminal must be clear of windows and doors. Pipes: the new runs from the boiler must be sized for the flow and insulated against frost, especially in a garage. Condensate: the pipe must fall to a drain, and outside runs need care in winter. And access: the boiler must be reachable for servicing, with space in front. A sketch of the proposed move helps the installer.
Heat Go can talk through a move. Send a sketch of the house, the proposed position and pictures of the current pipework, and points to resolve can follow.
The outside wall is close, so the flue is short. Ask how the new pipes will cross to the kitchen and bathrooms.
A garage is cold. Ask how the pipes and condensate line will be insulated, and whether the boiler stays frost-safe.
A boiler in the loft frees space below but needs a flue through the roof. Ask about access for servicing.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Houses with a side utility room | Drives common | Side door | Pipe runs |
| Houses with an attached garage | Roadside | Garage | Cold spaces |
| Houses where the loft has been converted | Permit zones | Landing | Loft siting |
Show the installer the proposed spot and the nearest outside wall. Say whether the walls are cavity, solid or timber frame.
A household decides to move the boiler from the kitchen to the utility room. The installer plans a short flue through the outside wall, new pipes in insulation under the floor and a condensate line to the utility sink waste. The old cupboard becomes storage. After the work, the boiler is easy to reach, and the household keeps a drawing of the pipe routes for the file. The installer notes how long the pipe runs are and fits clips every metre or so, so that nothing sags or knocks. Before leaving, he shows the household the new isolating valves in the utility room and explains which one shuts off the heating alone. The old cupboard shelves are put back for storage, and the drawing is pinned to the inside of the utility room door for anyone who needs it later.
A move needs more work than a swap. Planning in summer lets the survey, the order and the build fit before the cold begins.
The point on an outside wall or roof where the flue discharges.
The line that takes the slightly acidic waste water from a condensing boiler away to a drain.
The route a pipe follows between the boiler and the radiators or outlets.
Only where the flue, pipes and drain can be provided within the limits.
It adds work, so ask the installer to explain.
The terminal will be on the outside, but its position can be chosen.
Outside runs do, and the installer should say how.
Yes. It can be used for storage once the boiler is gone.
Gas emergency
If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.
Talk to Heat Go
Pass Heat Go your sketch and the name of your Mill Hill road, and the points to settle before a move can be returned.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All boiler servicesEvery service in Mill HillAll boiler installation areas