Highgate houses with lath and plaster partitions
The plaster may not hold a fixing. Ask for a timber plate behind it.
Boiler installation · Highgate
A modern boiler with water in it is heavy, and it hangs from a bracket on the wall, and the wall must carry that load for years. In a period house, the wall may be lath and plaster, thin brick or a stud partition. Anyone in Highgate planning an installation can ask the installer to look at the wall before the boiler position is agreed.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Larger houses in Highgate often have walls of different kinds in one room, with solid brick on the outside and lath and plaster or timber studs on the inside. A cupboard added later may be made of thin board. Ceilings are high, and the boiler may be hung well above the floor where the fixings are hard to check.
There are five things to settle. What the wall is made of, found by tapping, drilling a small test hole or removing a section of plaster. Where the studs or the solid brickwork lie, so the bracket can reach them. Whether the wall can carry the boiler, or whether a frame fixed to the floor and wall is needed. How the pipes will run to and from the boiler without cutting into joists. And how the fixing will be checked once the boiler is full. A frame or a plate of timber behind the plaster can spread the load. Ask the installer to explain the choice in plain words and to show the fixing before the boiler is hung.
Heat Go can put together the wall check with you. Describe the room and the wall, and a short list of fixing questions for the installer can be prepared.
The plaster may not hold a fixing. Ask for a timber plate behind it.
A stud wall may flex. Ask about a frame fixed to the floor.
Fixings hold well but drilling is slow. Ask about dust control and noise.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Highgate houses with lath and plaster partitions | Roadside | Kitchen | Soft walls |
| Highgate: conversions with thin stud walls between rooms | Permit zones | Landing | Stud partitions |
| Highgate houses with thick solid brick walls | Drives common | Utility room | Thick walls |
Show the installer the wall, the ceiling height and any pipes behind the plaster. Tell them if the room was altered in an earlier refit.
A household in a large Victorian house moves the boiler from a basement to a first floor cupboard. The installer taps the wall, hears hollow board, and opens a small section of plaster to find lath and thin studs. He fits a timber plate across two studs and bolts the bracket to it, then lifts the boiler into place. The household sees photographs of the plate before it is covered. Years later, a builder asked to remove the cupboard reads the note and knows exactly where the load is carried. The household keeps the photograph of the plate with the installer’s note, so that anyone who later alters the cupboard or the wall will know what lies behind the plaster.
Wall checks are easier in dry weather, when plaster is not damp from condensation and any cut section can be repaired quickly. A mild autumn leaves time for any frame to be built before the heating is needed. The fixing is also easier to inspect with the room cleared of furniture, so booking in a quiet period helps.
An old wall finish made of thin wooden strips covered in plaster.
A partition built from timber uprights covered in board.
The metal plate or rail fixed to a wall on which a boiler hangs.
A wall-hung boiler is heavy, and it holds water as well.
Not always; the installer should check what the wall is made of.
A board fixed behind the plaster to spread the load across studs.
Yes, ask for it to be shown and photographed before covering.
Leave and ring 0800 111 999, Highgate boiler installation can wait: leave, and Highgate boiler installation restarts when cleared.
Gas emergency
If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.
Talk to Heat Go
Tell Heat Go your Highgate street and the wall where the boiler will hang, and a list of fixing questions can be drafted.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All boiler servicesEvery service in HighgateAll boiler installation areas