Flats with landlord-owned boilers
Repairs go through the landlord, so report faults in writing and keep copies.
Central heating · Colindale
Heating in a flat often arrives with the building, and what you can change depends on what you own. Heat Go takes central heating enquiries from Colindale, and starts by finding out whether your system is yours, shared or provided by a landlord, since the answer decides who can repair, replace or adjust it.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Colindale’s Tube stop lies in fare zone 4 and dates from 1924, with plans to rebuild it approved in 2019. Hendon Aerodrome operated nearby until 1968, and the RAF Museum opened on part of the site in 1972. Houses and flats of different ages share the area, so heating systems range from long-established boilers to newer equipment in recent blocks. That range means no single piece of advice fits every home, and a short description of yours is the best starting point for a useful reply.
Whatever the age of the building, the same questions apply. What heats the water? How does it reach the radiators? What controls it? Who owns each part? In a flat, a landlord may own the boiler while a tenant uses the thermostat, which can lead to disagreements when something stops working. In a house, the owner holds all of it. Having the answers ready lets an engineer go straight to the likely fault, and saves a visit spent only on finding out who owns what.
Heat Go can advise on installation, repair, radiator replacement, flushing and controls. Tell the team whether you own, rent or lease, what the system is and which rooms are affected, and the reply can address the parts you can actually change, leaving the rest to whoever owns them.
Repairs go through the landlord, so report faults in writing and keep copies.
The owner arranges repairs but may need consent for changes that affect shared parts.
Owners look after the whole system, from boiler to radiator valves, and so should know where the filling loop and isolating valves are.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Flats with landlord-owned boilers | Permit zones | Common stairs | Reporting. |
| Owner-occupied flats | Check signs | Hallway | Consent. |
| Houses | Roadside | Utility room | Whole system. |
Most visitors orient themselves by the Tube stop and the museum nearby. For a visit, explain how to reach the boiler, whether it sits in a cupboard or loft and who will let the engineer in.
A tenant in a flat notices that the boiler shows an error light and the radiators stay lukewarm. She photographs the display, notes the code, checks the pressure gauge and writes to the landlord with these details. The landlord is able to pass them straight to an engineer. A clear report saves a wasted trip, and it gives the landlord a record that the fault was reported on a particular date, which matters if repairs are delayed.
Reporting a heating fault early in autumn gives landlords and agents time to act before demand peaks. A tenant who sends a written report, with photographs, in September is in a much stronger position than one who phones in the middle of a frost.
Landlords are generally responsible for heating equipment they provide. Report faults in writing.
Boilers display codes that point to a fault. Write them down, with a photograph of the display.
Low pressure is a common reason for a boiler to stop. Check the gauge and note the reading, then tell whoever looks after the boiler how often it happens.
In a rented flat, normally the landlord. In an owned flat or house, the owner.
It points to a fault area. The handbook lists codes, and an engineer can interpret them.
A small leak or a faulty valve is common. Note how fast it drops.
Often yes, but check your lease or tenancy for restrictions.
In writing, with photographs, dates and any codes.
Talk to Heat Go
Let Heat Go know if you own, rent or lease the flat, describe the fault and name your street, and the reply will set out sensible next steps.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All central heating servicesEvery service in Colindale