Flats in recently built blocks
Builders’ debris may lodge in pipes. Clear aerators and report persistent trouble.
Tap & toilet repairs · Colindale
A new flat’s kitchen or basin tap sometimes seems feeble. The water dribbles out, the kettle takes an age to fill and the household blames the building’s pressure. Often the cause is smaller: a clogged aerator, a flow restrictor, a half-closed isolating valve or debris in a cartridge, none of which needs a call-out to find. A few checks, none needing tools, can restore the flow. Residents of Colindale can try them in ten minutes, starting with the end of the spout, which unscrews by hand in nearly every case and often comes away with a visible pinch of grit.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Colindale’s newer blocks, near the station that sits in fare zone 4, are fitted with mixer taps that have aerators and, often, small flow restrictors, which keep use modest. In a new building, builders’ debris can lodge in pipes and valves during the first months, and fine grit clogs aerators. Isolating valves under the sink may be half-closed from the fitting.
The checks run from simplest to hardest. Unscrew the aerator at the end of the spout, rinse it and look for grit or scale, then refit it. Check the isolating valves beneath the tap: each should be fully open, with the slot in line with the pipe. Run the other taps in the flat to see whether the weakness is general or local. Look for a flow restrictor, a small plastic disc, in the spout or the connection, and note it but leave it. If the flow stays weak, send photographs and the make.
Which step is likely to help is something Heat Go can say, given a note of what you tried, photographs of the aerator and valves and the make of the tap.
Builders’ debris may lodge in pipes. Clear aerators and report persistent trouble.
Upper floors may have lower pressure. Compare with a neighbour’s tap.
A building problem affects every tap, so consult neighbours and the agent.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Flats in recently built blocks | Permit zones | Kitchen | New debris |
| Flats on high floors | Roadside | Top floor | Pressure |
| Flats on a building-wide supply | Drives common | Common hall | Shared supply |
Say which tap is weak and whether others are too, and where the isolating valves are. If the tap is in a kitchen unit, show how to reach the valves.
A tenant finds her kitchen tap barely trickles. She unscrews the aerator, which is clogged with grit, rinses it and refits it. The flow improves but remains modest, so she checks the isolating valves and finds one only half open. She opens it fully and the flow returns. She notes the date and tells the agent that builders’ debris may still be in the pipes, asking whether other flats have the same trouble.
Weak flow shows when kettles and washing machines are used more, in the colder months. A tidy-up of aerators and valves in October helps all season.
A small mesh at the end of the spout that mixes air into the water. Grit and scale block it.
A small disc that limits how much water passes. It is deliberate and should not be removed without advice.
A small valve under the tap. It should be fully open.
A clogged aerator, a half-closed valve or debris in the cartridge are the commonest causes.
Yes. Unscrew it by hand, rinse it and refit it.
No, because it is deliberate and may be part of the building’s design. Ask the plumber if it seems to be the problem, and why it was fitted.
The building’s supply or a partly closed main valve may be the cause. Tell the agent and ask whether neighbours have the same trouble.
It may be, so compare with neighbours and report it, with the floor you are on, since pressure can fall with height in a tall block.
Talk to Heat Go
Heat Go can suggest the likely cause when it receives a note of what you tried, the photographs and your Colindale address.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All plumbing servicesEvery service in ColindaleAll tap & toilet repairs areas