Gas appliance repairs · Barnet

Gas appliance repairs in Barnet: hob burners that click but will not light

A hob that clicks and clicks and will not light one burner while the others work is a very common complaint. The sparking works, so electricity is not the issue. The usual cause is simpler: the burner is dirty, damp or has been put back together slightly wrong. A few safe steps may cure it, though others need an engineer. People in Barnet can learn which is which, and the difference is usually clear from how the burner behaves after a gentle clean.

Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.

Gas Safe Register WaterSafe Heat Go G3 certified Heat Go Heating and Plumbing Engineer

Kitchens in Chipping Barnet have seen many cooks, and a hob used for years collects spilled food, grease and water in the burner. The dirt is entirely local to the pan that boiled over. A burner that is wet from a boil-over, or blocked by crusted food, will click without lighting, and a burner that is merely damp usually recovers after a few hours of drying.

There are four steps a household can safely try. Turn off the gas at the hob and let it cool. Lift off the burner cap and head, if the manual says so, and check that the small holes are clear, using a soft brush or a wooden toothpick, never a metal pin. Dry the parts thoroughly. Put them back exactly as they came, checking that they sit flat and in the right order, since a cap that is slightly crooked is one of the commonest reasons for a burner that clicks and does not catch. If the burner still will not light, or if a smell of gas appears, stop and report it.

Heat Go can say what to try, and what to leave alone, if it knows the hob and which burner fails. At any whiff of gas, switch off, leave the kitchen and dial the free emergency line.

Safe steps for a hob burner that will not light in a Barnet kitchen

Hob problems in different Barnet kitchens

Kitchens with a hob of some age

Grease and years of use clog the holes, and a careful clean may restore the burner.

Kitchens with a recent glass-topped hob

Spills near the burner base can short the spark. Wipe up and dry carefully.

Flats with a single hob in a galley

One burner may be used constantly. Heavy use wears the same parts first.

SettingParking and van accessProperty accessTypical enquiries
Kitchens with a hob of some ageRoadsideKitchenClogged burners
Kitchens with a recent glass-topped hobDrives commonKitchenSpill damage
Flats with a single hob in a galleyPermit zonesGalley kitchenHeavy use

Point out the hob and say when the fault began. A recent spill or boil-over, and anything you tried, points straight to the cause.

A household’s front-left burner stops lighting after a pan boils over. It clicks but does not catch. They turn off the gas, let it cool, lift the cap and find crusted food in the holes. They clean them with a toothpick, dry the parts and refit them. The burner lights. They note what they did, in case the fault returns, and they wipe the hob after every boil-over from then on.

Hobs get the most use in the colder months, when people cook more. Giving the burners a gentle clean in September lets small problems show up before the heavy season.

Good to know in Barnet

Burner cap and head

Removable parts that sit on the burner base. They must be dry and seated correctly.

Spark electrode

The small ceramic part that makes the spark. Keep it dry and free of spills.

Toothpick

A wooden toothpick is a safe tool to clear holes. A metal pin can damage them.

Questions about gas appliance repairs in Barnet

01Why does my burner click but not light?

It is usually dirty, damp or misplaced. Cleaning often cures it.

02Can I clean the burner myself?

Yes, the removable parts, following the manual. Do not open the hob’s gas parts.

03What if the spark stops altogether?

The ignition may have failed. An engineer should check it.

04Is it dangerous to keep clicking?

If gas is flowing without lighting, it is. Stop after a few seconds and ventilate.

05At what point is a call justified?

If cleaning does not help, report it. If gas is smelt at any time, switch off, get out and phone 0800 111 999.

Gas emergency

An emergency should not wait for an online enquiry.

If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.

Talk to Heat Go

Ask about gas appliance repairs in Barnet.

Which burner fails, what you tried and which Barnet road you live on are the facts Heat Go needs to suggest what is likely wrong. If gas is smelt, 0800 111 999 is the only number to use.

The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.

Gas appliance repairs enquiry

What can we help with?

All fields marked * are required

We reply to the contact details you give. A UK number such as 07700 900123 works fine.