Heat pump controls & optimisation · Barnet

Heat pump controls in Barnet: steady background heat or short bursts?

People used to boilers think of heating as something switched on to warm the house and off when it is warm. A heat pump works differently. It runs best at low output for long periods, holding the house at a steady temperature. Setting its controls with the old habit, short hot bursts, makes it work hard and may leave the house chilly. Barnet households with a heat pump can experiment with a gentler pattern.

Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.

Gas Safe Register WaterSafe Heat Go G3 certified Heat Go Heating and Plumbing Engineer

The houses around Chipping Barnet that now have heat pumps vary in how well they hold heat, from sturdy semis to draughty Victorian terraces. A well-insulated house barely cools overnight and suits steady heating. A leaky one cools quickly and needs more. In both cases, long, gentle running is usually kinder to the pump than switching off during the day and heating hard in the evening, though the leaky house will need a slightly higher target to feel as warm.

A sensible experiment has four steps. Set a single comfortable temperature, a degree or two lower than you would like at first. Set a modest set-back at night, a degree or two, not a deep drop. Leave the radiator valves open and let the pump run, resisting the urge to turn the target up at the first cool hour. Watch how the house feels over a week and adjust the target by half a degree at a time, asking everyone at home for their view, including the people who are always cold. Photograph the screens before and after each change, and keep notes, because a week later nobody remembers which number was which.

A pattern to try can be suggested by Heat Go, given a description of the house and the household’s day, plus the schedule you have now and how the house feels.

Trying steady heating on a Barnet heat pump

Schedule questions in different Barnet homes

Well-insulated houses

They hold heat overnight. A small set-back is enough, and steady running suits them.

Older houses with draughts

They cool faster. Steady running still helps, but check insulation too.

Flats between other flats

Neighbours’ heat keeps the flat warm. A lower target may suffice.

SettingParking and van accessProperty accessTypical enquiries
Well-insulated housesRoadsideLiving roomHeat-holding houses
Older houses with draughtsDrives commonHallwayLeaky houses
Flats between other flatsPermit zonesBedroomSheltered flats

Give the engineer your photographs and notes, and say where the controls are. A description of the household’s day helps.

A household that used to heat in two daily bursts, a morning one and an evening one, switches to a steady target of 19.5 degrees with a one-degree night set-back. For three days the house feels a little cool in the evening, so they raise the target by half a degree, then another half. By the end of the week, the house feels comfortable. The pump runs quietly most of the time, and they note the settings.

Steady heating is easiest to learn in autumn, when days are mild and the pump has little to do. The pattern can be adjusted before the cold of winter.

Good to know in Barnet

Set-back

A lower temperature held at night or when out, instead of switching off completely.

Target temperature

The room temperature the controls aim for.

Steady running

Heating at low output for long periods, as a heat pump prefers.

Questions about heat pump controls & optimisation in Barnet

01Should I switch the heat pump off during the day?

Usually not, since steady running suits it better than switching off and heating hard, and the house loses less heat if it never gets cold.

02How big a night set-back should I use?

A degree or two, not a deep drop. Deep drops need a big recovery.

03Will steady heating cost more?

Not necessarily, since it often suits a pump better, but compare your meter readings before and after, using the same weeks of the year if you can.

04Should I close radiator valves?

Mostly leave them open, so water flows freely, and use the room settings, not the valves, to control the temperature.

05How do I know if the pattern suits me?

Watch comfort and the meter over a few weeks, and ask everyone at home how the house feels at the times they are in.

Talk to Heat Go

Ask about heat pump controls & optimisation in Barnet.

Send Heat Go your current schedule and how the house feels, with your Barnet road, and a pattern to try can follow.

The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.

Heat pump controls & optimisation enquiry

What can we help with?

All fields marked * are required

We reply to the contact details you give. A UK number such as 07700 900123 works fine.