Plumbing installations · Edgware

Plumbing installations in Edgware: a utility room with its own sink, washing machine and waste

A utility room lets laundry, muddy boots and the dog’s towels live somewhere other than the kitchen. It also needs plumbing of its own: a sink, a point for the washing machine and often one for a tumble dryer’s condensate. Each needs a supply and a waste, and the waste must slope to the drain. Households in Edgware can settle the layout first and the pipes second, with a drawing of the room and a list of what will be plumbed in.

Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.

Gas Safe Register WaterSafe Heat Go G3 certified Heat Go Heating and Plumbing Engineer

Many houses near Edgware station, whose line opened in 1924, have a garage or a side extension that can become a utility room. The room is often on the outside of the house, so the pipes must run through a wall or under a floor from the kitchen. A concrete floor means any waste must be placed before it is laid, and a new connection to the drain needs care.

Five points matter. The position of the sink and machine, with room to open the door and reach the valves. How the hot and cold feeds will reach the room, probably from the kitchen. The route and fall of the waste, which may join the kitchen waste or go straight to a gully. Ventilation or an air break where required, so that the waste does not siphon. And the access to every valve and joint after the units are fitted. A drawing helps the plumber check each point.

Heat Go can talk through the supplies and waste of a utility room. Send a drawing, a list of appliances and a photograph of where the waste pipes are, and a short reply can raise points to settle.

Planning the plumbing for a utility room in Edgware

Utility room questions in different Edgware homes

Houses with a converted garage

The floor is concrete. Ask whether the waste must be laid before the floor or can be run on the surface.

Houses with a side extension

The pipes run from the kitchen through a wall. Ask for a sleeve and seals where they pass through.

Flats with a laundry cupboard off the hall

Space is tight. Ask for valves that can be reached and a waste that does not need more room than the cupboard has.

SettingParking and van accessProperty accessTypical enquiries
Houses with a converted garageDrives commonGarage doorConcrete floors
Houses with a side extensionRoadsideSide doorWall crossings
Flats with a laundry cupboard off the hallPermit zonesHallwayCupboard space

Tell the plumber which wall is outside, what the floor is made of and how the drain outside is reached.

A couple convert a garage into a utility room. The plumber sets out the waste before the floor is laid, branches the cold and hot supplies from the kitchen and fits valves beside the machine. The waste has an air break and joins a gully outside. After the floor is finished, the pipes are tested and a drawing is made of the routes, which the couple keep with their house papers. They also note where the outside gully is and make sure that leaves do not collect round it. Once the room is in use, the washing machine is run through a full cycle with the plumber’s sketch to hand, and the couple check each joint for a drip before the units are finally boxed in.

Floors and walls are easier to work on in dry weather. A utility room planned in the summer can be finished by September, before the cold arrives and the laundry piles up.

Good to know in Edgware

Air break

A gap in a waste pipe that stops dirty water being drawn back into an appliance.

Gully

A drain outside a house that receives waste water from pipes and carries it to the sewer.

Condensate

The water that collects from a tumble dryer or a boiler and must be drained away.

Questions about plumbing installations in Edgware

01Can a utility room be added anywhere?

Where a supply and a waste can be provided with a proper fall.

02Does the waste need an air break?

Often, to stop water being drawn back into an appliance.

03Can pipes run through the floor?

Yes, before the floor is laid, or on the surface in a duct.

04Where is the best place for the valves?

Beside the machine, where they can be reached.

05How do I keep a record?

Ask for a drawing or photographs of each route.

Talk to Heat Go

Ask about plumbing installations in Edgware.

Send Heat Go your drawing and Edgware road, and a short list of plumbing points can be suggested.

The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.

Plumbing installations enquiry

What can we help with?

All fields marked * are required

We reply to the contact details you give. A UK number such as 07700 900123 works fine.