Houses with a boiler in a cupboard with vents
The vents are the boiler’s air supply. Keep them clear and do not cover them with shelves.
Boiler safety checks · Mill Hill
A boiler needs air to burn fuel cleanly. Some take it from the room, others from outside through the flue, and either way the supply must not be cut. A house that has been made airtight, with new windows, sealed gaps and a closed-off chimney, may leave a room-sealed boiler unaffected but a room-ventilated one short of air. Households in Mill Hill can check the arrangement, and keep vents open.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Houses around Mill Hill have often been upgraded over the years with double glazing, extensions and draught-proofing. An older boiler in a cupboard or garage may rely on a vent in the door or wall. If that vent is covered, painted over or blocked by stored items, the air supply falls. The maker’s instructions say what the boiler requires.
The checks involve little effort. Find out whether the boiler is room-sealed or takes air from the room, using the manual or the label. Look for vents in the cupboard door, the wall or the room, and make sure they are clear. Check that nothing is stored against the boiler or over a vent. Notice whether a recently added extractor fan or sealed chimney has changed the room’s air. And have the engineer note the ventilation on the next service sheet. A short list of observations helps them judge it.
Heat Go can help you check what a boiler needs. Tell us what you know of the boiler and the room, and a list of questions can be set out.
The vents are the boiler’s air supply. Keep them clear and do not cover them with shelves.
A strong fan can draw air away from an open-flued boiler. Ask the engineer to check.
Closing a flue can change how air moves. Ask whether the boiler is affected.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Houses with a boiler in a cupboard with vents | Drives common | Kitchen | Cupboard vents |
| Houses with a recent extension and a new extractor fan | Roadside | Rear extension | Extractor fans |
| Houses with a blocked-up chimney | Permit zones | Living room | Closed chimneys |
Tell the engineer about any work done to the house, such as new windows or a closed chimney, and show them the vents.
A household in an older house has new windows fitted. They check the boiler’s manual and find it takes air from the room, through a vent in the cupboard door. They look at the vent and find it covered by a shelf. They clear it and tell the engineer, who checks the boiler. The air supply is adequate. The household notes the vent’s position on a card. The engineer also points out that a tumble dryer vented into the same room could compete for air with an open-flued boiler, and the household decides to keep the dryer’s outlet clear and the room door slightly open while it runs. The card the household makes lists the vent positions, the boiler type, when it was last checked and who did it, and goes into the folder with the service sheets. The next time any building work is planned, it is the first thing they take out.
A ventilation check is best made after any work to the house, and again each September, before the heating season.
A boiler that takes its air from outside and sends its exhaust outside, sealed from the room.
A vent that lets air reach an appliance or a room.
An appliance that takes air from the room and sends its exhaust up a flue.
Only some do. The manual says.
No. Keep it clear.
They can reduce the air that reaches an open-flued boiler.
Get out, ring 0800 111 999 first and do not use switches or flames.
It may, with an open-flued boiler. Ask the engineer.
Gas emergency
If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.
Talk to Heat Go
Tell Heat Go about your boiler and any recent work, naming your Mill Hill street, and questions about ventilation can follow.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All boiler servicesEvery service in Mill HillAll boiler safety checks areas