Houses with a tap beside the back door
The pipe is short and the valve is usually close. Isolate it in October.
Tap & toilet repairs · Mill Hill
An outside tap is easy to forget until a frost splits it, usually on the coldest night of the year. The water inside freezes, expands and cracks the body or the pipe behind, and the damage shows only when the thaw comes and water pours into a wall. Draining or isolating the tap before winter prevents it, and takes five minutes per tap. Households in Mill Hill with large gardens often have more than one outside tap, and each deserves a minute in October, with a note of where it is.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Mill Hill’s gardens and the long runs of pipe to reach them mean many outside taps in many places: beside the back door, on a garage wall, at the end of a side passage. Some have an isolating valve inside the house, some do not. A tap with no valve, left full, is the most likely to burst, and a hose left on it makes the damage more likely still. The pipe may be hidden in a wall.
The autumn routine is straightforward. Find each outside tap and trace its pipe to where it enters the house. Look for an isolating valve, usually with a small cap or drain on its side, inside a cupboard or garage. Close the valve, open the outside tap to drain the pipe and leave it open. Disconnect any hose and bring it in. Fit an insulated cover if you have one. If there is no valve, say so, and have one fitted. Write down where each tap is and its valve.
Heat Go can say whether a tap needs a valve and what to ask. Send photographs of the tap and the pipe, and a note of where it enters the house.
The pipe is short and the valve is usually close. Isolate it in October.
A long pipe in an unheated space freezes first. Check for a valve.
A communal tap belongs to the building. Tell the agent if it has no valve.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Houses with a tap beside the back door | Drives common | Back door | Short runs |
| Houses with a tap on a garage | Roadside | Garage | Cold runs |
| Flats with a shared garden tap | Permit zones | Rear garden | Shared taps |
Say where each outside tap is and where its valve is, and whether the way to it is clear. A plan of the garden helps.
A householder finds a split tap on the side wall after a freeze and a damp patch inside the garage, which she first takes for condensation. She photographs both, closes the stopcock and has the tap and a short length of pipe replaced, with a valve fitted inside. The next autumn, she drains and covers it. She writes the date on a card in the garage, and sets a reminder on her phone for the following October.
The first frost can come in November. A walk round the garden in October, with a notebook, closes every outside tap in time.
A tap indoors that shuts off the pipe feeding the outside tap, so the pipe can be emptied.
Opening the outside tap after closing the valve so the water runs out of the pipe.
A foam or fabric hood that protects a tap from frost.
Close its valve, open the tap to drain, remove the hose and cover the tap.
Have one fitted. Without it, the pipe cannot be drained.
It helps, but draining the pipe is far better, since a cover only slows the freezing and cannot stop it in a hard frost.
Close the stopcock and report it at once, because water may be running into the wall and the leak will show only as a stain later.
In October, before the first hard frost, and again in spring when the tap is wanted, remembering to reopen the valve and check for drips.
Talk to Heat Go
Whether valves are needed can be judged once Heat Go sees a photograph of each outside tap and learns your Mill Hill street.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All plumbing servicesEvery service in Mill HillAll tap & toilet repairs areas