Houses with a new rear extension
The old kitchen vent may now open into a different room. Ask the engineer to check airflow.
Gas safety checks & certificates · Mill Hill
Building work changes a house in ways that matter to its gas appliances. A new extension may cut off ventilation, a refitted kitchen may move the cooker and a sealed chimney may change how a fire draws. The work may have been done well, but a check afterwards shows that everything still works safely. Households in Mill Hill can arrange one at the end of a project and tell the engineer what changed.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Many Mill Hill houses have been extended or refitted, sometimes more than once. Each project can affect gas appliances: pipes may have been moved or capped, vents covered, flues boxed in, and the layout of rooms altered. A check after the work reviews all of this, not only the new part. The engineer should be told what was done and by whom.
A useful briefing covers five points. What building work was done, and when. Which gas appliances were moved, added or removed, and who did the gas work. Whether any vents, chimneys or flues were altered or covered. Whether any new fans or extractors were fitted. And whether any appliance has behaved differently since the work. With these, the engineer can focus the check on the places most likely to have been affected, and note the changes on the record.
Heat Go can help you draw up a briefing. Tell us what work was done and what has changed, and a short summary for the engineer can be put together.
The old kitchen vent may now open into a different room. Ask the engineer to check airflow.
The cooker may have been moved. Ask for the connection and the restraint to be checked.
A sealed chimney affects air and flue paths. Ask whether any gas appliance relied on it.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Houses with a new rear extension | Drives common | Rear extension | Altered ventilation |
| Houses with a refitted kitchen | Roadside | Kitchen | Moved cookers |
| Houses where a chimney was sealed | Permit zones | Living room | Sealed chimneys |
Give the engineer the dates and a short list of the work. Show them the rooms that changed and anything that looks different.
A household finishes a kitchen and extension. The cooker has moved and the old chimney is sealed. They write a short note of the work and give it to the engineer, who checks the cooker connection, finds the vent in the old kitchen now opens into a cupboard and advises moving it. The boiler and the fire are checked. The new record lists the changes. The household files it with the builder’s invoices and the photographs of the work, so that anyone who asks about the gas side of the project can see the whole story in one place. The engineer adds that the best time to arrange a check is before the builder leaves, so that anything found can be put right while the team is still on site. He suggests asking the builder to leave any access panels unfixed until the check is done, which the household finds a sensible precaution, and they write it into the builder’s final snagging list so that nothing is closed up before the engineer has seen it. The engineer also recommends keeping the photographs of any pipework before plaster went on, as these are the clearest record of where the pipes run.
A check at the end of building work is best made as soon as the dust settles, and again before the heating season. A September visit does both.
The air a room or appliance draws in so that gas can burn cleanly.
A chain or bracket that holds a cooker so it cannot strain its gas connection.
A gas pipe closed with a fitting because it is no longer used.
Work can change ventilation, flues and pipework.
A competent installer, and the record should say who.
Leave at once, ring 0800 111 999 before anything else and keep clear of flames.
What was done, when, and anything that behaves differently.
No. They supply air that appliances need.
Gas emergency
If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.
Talk to Heat Go
Tell Heat Go what building work was done, naming your Mill Hill road, and a briefing for the engineer can be written.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All gas servicesEvery service in Mill HillAll gas safety checks & certificates areas