Gas leak investigation · Highgate

Gas leak investigation in Highgate: old iron pipework under floors in a large house and how an investigator tests it in sections

Large old houses often carry gas pipes that are older than the owners. Iron pipes run under floors, behind plaster and through cellars, and joints can weep after decades. After a smell and a call to 0800 111 999, the investigator may test the pipework in sections to narrow down the fault. Households in Highgate can understand the method and plan for the work.

Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.

Gas Safe Register WaterSafe Heat Go G3 certified Heat Go Heating and Plumbing Engineer

Many houses in Highgate have been altered many times, with pipes added, moved or capped over the years. A pipe that once fed a kitchen may now feed a fire, and a section may be buried under a new floor. Nobody may know where each length runs.

There are five stages to testing in sections. The investigator isolates the supply and checks the meter. Each run is closed at a valve and tested for pressure loss. The run that loses pressure is divided further, until the fault lies in one length or joint. The floor or plaster is opened at that point, and the pipe is repaired or replaced. A full test follows, and appliances are checked before the supply is restored. Ask for a sketch of the pipe routes, marked with the tested sections and the repair. Keep it for the next owner. The work can be messy, so move furniture and cover floors.

Heat Go can help you plan the work. Describe the house and its alterations, and a short brief for the investigator can be written.

Preparing a large Highgate house for sectional testing of old gas pipework

Testing old iron pipes in Highgate houses

Highgate houses with iron pipes under timber floors

Boards may need lifting. Ask how the floor will be made good.

Highgate houses with a cellar and old pipework above

Pipes run through the ceiling. Ask for access to the cellar.

Highgate: conversions where pipes serve several flats

Pipe runs are many. Ask for each flat to be tested.

SettingParking and van accessProperty accessTypical enquiries
Highgate houses with iron pipes under timber floorsRoadsideHallwayFloor openings
Highgate houses with a cellar and old pipework aboveDrives commonCellarCellar routes
Highgate: conversions where pipes serve several flatsPermit zonesShared hallMany pipe runs

Give the investigator any old plans or records, and show the capped or altered pipes you know of. Say which rooms hold the oldest pipework.

A household in a large house smells gas in the kitchen, calls 0800 111 999 and waits outside. After the supply is made safe, the investigator tests the pipework in sections. The kitchen run loses pressure, and the next test narrows it to a joint under the floor. The boards are lifted, the joint is repaired and the run is tested again. The investigator draws a sketch of the pipe route and gives it to the household, who file it with the house papers. The household also asks the investigator to mark on the sketch where any pipe is still iron and where it has been replaced with newer material, so that the picture shows the whole system. He agrees and adds colour to the drawing. A later buyer’s surveyor reads the sketch and asks only two questions, both answered in the folder. The plan to replace the oldest sections over the next few years is also written on the sketch, with a rough order of work, so the household can spread the effort over time.

Sectional testing takes time, so a calm, dry period is helpful. In winter, a household may be without heating and hot water for part of a day while the work proceeds. A sketch of the pipes is especially valuable when the next owner plans building work. Old iron pipework is most often found in houses that have not had major building work for decades. A calm, dry period is best for sectional testing, since floors are lifted and plaster opened. Winter work is possible, but the household may be without heating and hot water for part of a day, so planning matters.

Good to know in Highgate

Pipe run

A pipe that leaves the main supply pipe to serve one part of a building.

Pressure loss

A fall in pressure in a closed pipe that suggests a leak.

Made good

Repaired and finished so that no trace of the work remains.

Questions about gas leak investigation in Highgate

01In Highgate, how does sectional testing work?

The pipe is divided and tested until the fault is found.

02In Highgate, will floors be lifted?

Possibly, at the point of the fault.

03In Highgate, who makes good afterwards?

Ask the investigator to say what is included.

04In Highgate, is a sketch useful?

Yes, it helps future owners and builders.

05Highgate: gas leak investigation and a gas smell?

First, 0800 111 999 is rung; Highgate gas leak investigation can wait: leave, and Highgate gas leak investigation resumes later.

Gas emergency

An emergency should not wait for an online enquiry.

If you suspect a gas leak, call the National Gas Emergency Service immediately on 0800 111 999. The enquiry form below is for non-emergency questions.

Talk to Heat Go

Ask about gas leak investigation in Highgate.

Tell Heat Go the Highgate street and what you know of the pipework for gas leak investigation, and a brief for the investigator can be drafted.

The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.

Gas leak investigation enquiry

What can we help with?

All fields marked * are required

We reply to the contact details you give. A UK number such as 07700 900123 works fine.