Highgate: properties with the unit on a clay lawn
Water may pool. Ask the installer about a drainage bed.
Heat pump maintenance · Highgate
An outdoor heat pump makes meltwater when it defrosts, and in winter that water must drain away. If it freezes at the base or in the drain pipe, ice can build up and reach the fan or the coil. A frozen base is a hazard for the unit and for anyone walking by. Households in Highgate with larger grounds can plan for meltwater and keep the base clear.
Certified for the work. Heat Go holds Gas Safe, WaterSafe, G3 and heating and plumbing certification. Call +44 7551 336264 to talk it through.
Many larger properties in Highgate have a heat pump on a slab or on feet beside a path, a terrace or a lawn. The ground may be clay, and the slab may not slope. A drain pipe may run from the base to a soakaway or a gully, and a pool at the base can freeze in hard weather.
Five habits help. Look at the base after a defrost on a cold morning to see where meltwater goes. Check that the base drains freely, and that the drain pipe or soakaway is not blocked by leaves, silt or ice. Keep the area round the base free of snow and slush, clearing it gently with a soft brush and not a spade. Never chip or pour hot water on ice at the unit, which can damage the coil or the casing. If ice builds up on the unit itself, or the unit stops, switch off at the isolator and call. A trickle of warm water from a hose is not advised either. Note any pooling and tell the engineer.
Heat Go can draft a winter meltwater check list for your unit if you describe the base and the drain.
Water may pool. Ask the installer about a drainage bed.
Ice on the path is a slip risk. Keep meltwater off it.
It may silt up. For heat pump maintenance in Highgate, ask the engineer to check it.
| Setting | Parking and van access | Property access | Typical enquiries |
|---|---|---|---|
| Highgate: properties with the unit on a clay lawn | Roadside | Lawn | Poor drainage |
| Highgate: properties with a unit beside a path | Drives common | Path | Path ice |
| Highgate: properties with a soakaway under the base | Permit zones | Garden | Soakaways |
Show the engineer where water pools and where the drain runs. Tell him on which mornings ice has formed and how long it lasted.
A Highgate household with a heat pump on a slab by a garden path sees a sheet of ice form on the path on a cold morning. They note the date, the temperature and that the meltwater runs onto the path. They clear the snow gently, tell the engineer and photograph the base. He finds that the slab has settled and that the drain outlet has silted up. He clears the outlet, shims the slab to slope away from the path and advises a gravel bed. The ice stays clear of the path from then on, and the household keeps the note. The household also writes down the engineer’s advice on the soakaway, with the date it was cleared, and sets a November reminder to look at it.
Ice problems arise from December to February, so a check of the base and drain in November gets ahead of the cold. A heavy frost after a wet autumn is the hardest test. In spring, a look at the base shows what the winter did.
A pit filled with gravel or stone that lets water drain slowly into the ground.
Water produced when ice melts, as when a heat pump defrosts its coil.
A thin wedge placed under an object to level it.
Meltwater from defrost can freeze if it does not drain.
No, it can damage the unit.
The engineer, at a service, and you by eye.
Yes, so keep meltwater away from walkways.
Call 0800 111 999 first, so Highgate heat pump maintenance stays paused, and Highgate heat pump maintenance carries on later.
Talk to Heat Go
Describe your base and drain to Heat Go, and a winter meltwater checklist for the unit will be written.
The quickest way to talk to a Gas Safe, WaterSafe and G3 certified team is to call +44 7551 336264.
All heat pumps servicesEvery service in HighgateAll heat pump maintenance areas